6th & 7th October 2026
Radisson Hotel & Conference Centre London Heathrow
17th May 2027
Hilton London Canary Wharf
Education Technology Forum

School Wi-Fi: Meeting DfE wireless standards and choosing a provider

Dead spots in the science block, connections that drop when a whole class logs on at once and access points that stopped receiving updates years ago: these are the usual reasons a school Wi-Fi project starts. When the problems point to an ageing or unsupported network, the Department for Education (DfE) wireless standards are the starting point for an upgrade. The harder part is turning them into a specification that fits how your school uses Wi-Fi, including the infrastructure and support behind it.

What the DfE wireless standards mean for an upgrade

The government has set six core digital and technology standards for schools and colleges in England to work towards by 2030, and wireless networks and network switching are two of them. The wireless network standard applies when you upgrade an underperforming or unsupported solution, so it shapes your next specification rather than forcing you to replace a network that still works.

For new equipment, the DfE expects the latest Wi-Fi Alliance standard, currently Wi-Fi 7 (802.11be). A Wi-Fi 6 or 6E network that performs well and is still supported can stay in service, but new access points shouldn’t be specified on an older generation.

An access point can only pass on the bandwidth its switch port and cable can carry, so the switching and cabling guidance matters just as much. The main expectations for an upgrade are:

  • Wi-Fi generation: Wi-Fi 7 (802.11be).
  • Coverage: heat mapping during planning, with an indicative density of up to one access point per classroom and higher-specification units in busy areas such as halls.
  • Management: central tools to configure, monitor and alert, with automatic security updates backed by manual checks.
  • Switching: at least 1Gbps to desktop devices, multi-gigabit ports for access points, uplinks to the core of at least 2x10Gbps and at least five years’ warranty and support.
  • Cabling: Category 6A copper when you upgrade wireless, and a minimum of 16-core multimode OM4 optical fibre between buildings.

Source: DfE wireless network, network switching and network cabling guidance, updated 16 September 2026.

If new access points need faster ports or more power than your switches can supply, that work belongs in the first quote, not a variation once installation has started.

Survey and design before you buy

A specification tells you what to buy, but not how much of it or where. The DfE expects providers to design around your needs, using heat mapping and matching coverage in each space to the number of people using it at once.

Ask what the survey will produce. A useful design pack includes a coverage map with proposed access point locations, expected device numbers in each space and an assessment of your switching, power and cabling.

The design should also reflect how each area is used. A classroom’s needs depend on how many pupil and staff devices connect at once, while a hall hosting online exams creates very different demand from one used for assemblies. Base the design on your real peaks.

A survey predicts performance, so ask how coverage will be checked after installation and what remedial work is included if results fall short.

Security and safeguarding

Coverage is only one part of the design. The network must also give staff, pupils and guests the right access while keeping unauthorised users out. The DfE identifies several measures schools may need, including virtual local area networks (VLANs), secure guest access, WPA3, certificate-based authentication and multi-factor authentication for privileged users. Your provider should explain which controls suit your environment.

Safeguarding works to a different timescale. Unlike the infrastructure standards, the filtering and monitoring standard is one schools should already be meeting. Filtering should cover school-managed devices, including those used off-site, as well as personal and guest devices accessing the school network. Monitoring may involve device software, network logs and staff supervision, so check that each approach is appropriate across your sites and devices. Wireless security is one layer of a wider plan, and choosing cyber security products and services for schools also involves backups, incident response and supplier support.

How to compare school Wi-Fi providers and service models

Security and performance both need attention after installation, and the service model decides who monitors the network, applies updates and responds when equipment fails. The main options are:

  • Buy and own: your school purchases and manages the equipment, with a support contract covering licences, firmware and security updates.
  • Owned equipment with managed support: a provider monitors and supports your equipment under a service level agreement (SLA).
  • Wi-Fi as a service: a subscription, often priced per access point, where the provider usually supplies and refreshes the equipment. Ownership terms vary.

To compare proposals fairly, work out the whole-life cost: survey, equipment, installation, extra cabling or switching, licences, support, refresh and exit. Check what happens if equipment loses support during the contract, and what the SLA promises when an access point fails during a lesson.

Academy trusts should also consider the accounting implications. Under the DfE’s leasing guidance for academy trusts, updated in September 2026, trusts must assess whether a contract contains a lease, and most leases are now recognised on the balance sheet unless an exemption applies. Involve your finance lead before signing.

Buying routes and funding

Capital purchases and service contracts are budgeted and procured differently. The DfE’s Get help buying for schools service lists approved ICT frameworks covering networking equipment, connectivity and managed services, so check each one’s scope against your requirement.

Before approaching suppliers, you can use the DfE’s Plan technology for your school service to assess your position against the standards, and trusts can assess several schools at once.

Connect the Classroom is the DfE’s dedicated Wi-Fi funding programme. It currently supports schools that receive targeted intervention through the RISE programme and whose Wi-Fi falls below the DfE’s connectivity standards, and the DfE contacts eligible schools directly. Schools not contacted by the DfE should not assume they qualify for Connect the Classroom funding. They should check the latest eligibility guidance and consider other available funding routes or existing budgets.

Where several schools are being upgraded, a shared specification and management platform can make performance easier to compare and future purchases easier to plan, as long as it allows for differences between buildings.

Questions to ask before you sign

  • What design assumptions sit behind the survey, and how will coverage be checked after installation?
  • Does the price include the switching, power and cabling work the new access points need?
  • What are the response and fix times, and who resolves a fault?
  • Who owns the equipment at the end, and what does it cost to leave?

Take your Wi-Fi requirements to the Ed.Tech Summit

The Ed.Tech Summit on 17 May 2027 at Hilton London Canary Wharf is a chance to put these questions to suppliers. The event offers pre-arranged one-to-one meetings in 20-minute slots, with schedules informed by the requirements and preferences buyers share, alongside a seminar programme. Wi-Fi infrastructure is one of the areas buyers can select when they apply.

Attendance is complimentary for qualifying buyers, subject to the event’s booking and attendance terms.

Check your eligibility and apply to attend

Frequently asked questions

What are the DfE wireless standards for schools?

For schools in England, the wireless network standard sets four expectations: the latest Wi-Fi standard, full coverage, central management and protection from unauthorised access. It applies when an underperforming or unsupported solution is upgraded.

Do schools need Wi-Fi 7?

The DfE expects new wireless equipment in schools in England to use Wi-Fi 7 (802.11be). A supported Wi-Fi 6 or 6E network that performs well doesn’t need replacing just to change generation.

How many access points does a school need?

The DfE gives an indicative figure of up to one per classroom, but room size, construction and device numbers all affect the answer. A survey is more reliable than a rule of thumb.

Image credit: https://unsplash.com/photos/white-router-on-black-table-mhA3QOXME5M

YOU MIGHT ALSO LIKE

Leave a Reply

Your email address will not be published. Required fields are marked *